Dear Sir,
I would like to clarify the misunderstanding here:
I have not presumed that we are not covered by ESIC. Infact I asked for details regarding exemption because the factory we have recently commissioned is in Uttarakhand and ESI is applicable in the region where our factory is located.
I am presently located at Valsad, Gujarat where ESIC is not applicable and I dont have much knowledge and experience regarding ESIC, hence I requested for opinions from other members.
As such my post to which you are referring is about my current location (guj) where I have to travel around 150 km to meet any ESIC official. I thank you for suggesting to correspond with ESIC authority.
However, as mentioned in my previous two posts we have decided to go for registration for ESIC and already the process for the same is initiated.
Once again I confirm the original purpose of my post:
If there is some exemption available for new manufacturing units under ESI, we would like to avail them as we would like to have some time before we achieve the break-even point and help our administration department to streamline the liaison work.
However, as there is no such exemption available, we have decided to comply to statutory requirements and apply for registration.
Hope I have cleared whatever misunderstanding was caused.
Thanks for your response and guidance again.
Regards,
Hiten
I would like to clarify the misunderstanding here:
I have not presumed that we are not covered by ESIC. Infact I asked for details regarding exemption because the factory we have recently commissioned is in Uttarakhand and ESI is applicable in the region where our factory is located.
I am presently located at Valsad, Gujarat where ESIC is not applicable and I dont have much knowledge and experience regarding ESIC, hence I requested for opinions from other members.
As such my post to which you are referring is about my current location (guj) where I have to travel around 150 km to meet any ESIC official. I thank you for suggesting to correspond with ESIC authority.
However, as mentioned in my previous two posts we have decided to go for registration for ESIC and already the process for the same is initiated.
Once again I confirm the original purpose of my post:
If there is some exemption available for new manufacturing units under ESI, we would like to avail them as we would like to have some time before we achieve the break-even point and help our administration department to streamline the liaison work.
However, as there is no such exemption available, we have decided to comply to statutory requirements and apply for registration.
Hope I have cleared whatever misunderstanding was caused.
Thanks for your response and guidance again.
Regards,
Hiten