Tamil Nadu Da Revised 2012 - Reg; - Pdf Download

Dear all,
please find enclosed the tamil nadu da revised for the year 2012-13 for your ref.
With regards,
shanky

For General engineering and Fabrication Industry-Minimum Wages worked out and enclosed in Excel sheet.
Regards
D Pannerselvam

Dear pannerselvam,
please find enclosed revised minimum wages (Basic) published on feb'2012 for general engg & fabrication for your ref.
Please refer page 152-153;
with regards
SHANKY

Dear Shanky,
Pl find the attached MW for general Engg and Fabrication Industry.
I have worked out based on the notification. Pl revert whether correct or not?
Rds
D Pannerselvam

DEAR PANNERSELVAM,
I saw your sheet, based on my working it shows difference compare to your working. My working are given below;
I Just worked for Unskilled Category, based on this your arrive for other category.
ZONE A ; UNSKILLED = BASIC = Rs.123/-per day (123 *26 = Rs.3198 + Revised DA Rs.2238/-
Total = Rs.5436/- (One day it comes to Rs.209/- per day).
ZONE B : One day wages it comes around Rs.206/-
This is for your information.
With regards,
SHANKY

Hi Shanky,
Will you please provide T N SHOPS & COMMERCIAL ESTABLISHMENT registration form and also fees slab of the same.
It is little urjent.
Regards,
GEM

GEM,
There is no provision to register the establishment under the TN Shops and Establishment Act,1948.
1. No such registration form required to register your establishment.
2. Not necessary to remit fee.
Act says about to maintain the following registers and show the records during inspection by Asst Inspector of Labour.
a. Form -o Half yearly return
b.Form -P Registers of advances paid,deductions for damage,loss and fines
c.Form Q- Register of Employment for shops and Establishments
d. Form R- Register of wages
e. Form S- Notice of daily hours of work,Rest intervals, Weekly holidays
f.Form T- wAGE SLIP/Leave Card
Regards
D Pannerselvam
9842219133

Dear Kumar,
Enclosed TN Minimum wages on General Engg and Fabrication Industry.
Regards
D Pannerselvam

Dear All,
Basic amount is calculated based on the Draft notification.
Approved circular yet to come.
If anybody have a circular on basic amount, pl circulate.
Regards
D Pannerselvam

Hi Panner,
I have long been waiting to see this working sheet which i could not recollect.
Its so good to see people sharing knowledge and views.
Together we can
Regards,
Vijay