No Tags Found!

abhaygirish
49

Dear Seniors,
QUESTION IS FROM MY SAFETY OFFICER IS :
What parameter should be consider for Dyke wall construction as well as is there standard guideline for Dyke wall of
1. other than Petrolium materials ( acid, alkali , toxic etc..)
2. Petrolium materials
Regards,
Abhay

From India, Mumbai
dipil
713

Dear Abhay
Just go through the below link:
CR4 - Thread: Dyke Wall Dimension for Storage of Chemical
Hope this will help you somehow...

From India
abhaygirish
49

dIPILJI , Thanx
I used that earlier but not got enough information,
Regards,
Abhay

From India, Mumbai
tgpenney@gmail.com
11

Dipil asked me to help you on this chemical question

The two questions around dyke operations are simple

The first are you keeping out contaminents or trying to contain chemicals from spilling or leaching out

The nest is it inside risks or out side storage risks

After that the risk factors are simple to build

The first thing is the type of chemical you are protecting

Second is risk when building like heavy traffic in the area

the spillage to leakage to damange to the dyke ( like the fire rating on a steal door how long before the chemical breaks down the dyke or if equipment is used around it shock impact to dyke strength if someone hits it

The standard is 36 inches off the ground and a minimum of re-enforced steel inlayed cement about6- 8 inches thick

Plus there is the matter of contaiment of chemical and inner contaments and they too must be collect inside the dyke area

So if you anser these guestions the rest of the question is easy

With a ladder stair way point of entry except this now become confined space because of the ergess point

For petro chemicals a 30 degree built up berm is layed on the outside area as an additional protective barrier with grounding rods put out side the wall area to the tanks to prevent electrical discharge

The inner flower is re-enforced also with a six inch base and the whole area has a built in protective liner pending the chemical to prevent letching of the product

From Canada, Calgary
dipil
713

Dear Terry
Thanks a lot for your input and clearing the doubts of Mr. Abhay...
Keep on sharing and reqquested to keep on participate into the forum discussions and share your expertise with us...
Once again thanks a lot...
@ Abhay: Nice to know that you get solution through our beautiful forum...

From India
srinivasan_ts
3

Dear Sir,
Regarding the Dyke wall is whether Petrolium materials or chemicals the size of holding of the Dyke wall is 1.25 times the total capacity of the tanks of storage.
The flooring type will vary according the type of materials we use.
regards,
T.S.SRINIVASAN

From India, Pondicherry
kvsundaram
68

hi abhay,

pls. find some input from my side on the same,

1. Secondary containment for a single container (tank) should be 110% of the primary container

2. Secondary containment for multiple containers should be 150% of the largest container's volume OR 10% of the aggregate volumes of all containers, which is greater.

3. All secondary containment systems open to rainfall must be able to hold 4.5 inches of rainfall in addition to the required secondary containment volume.

4. All secondary containment systems open to fire sprinkler discharge must be able to hold the discharge from all sprinkler heads over the secondary containment system for 20 minutes in addition to the required secondary containment volume.

5. The dyke for the storage tanks should have a mininmum height of 30 cm.

6. The dyke and dyked area is lined with a material that is compatible (chemically resistant) with the material being stored.

7. Uncontrolled drainage from a secondary containment system is not allowed. Accumulated rainwater or sprinkler flow water may only be released from a secondary containment system after it has been determined to be uncontaminated. The drainage system must be kept closed or pumps turned off unless the drainage process is monitored.

8. Materials that in combination may cause a fire or explosion, or the production of a flammable, toxic, or poisonous gas, or the deterioration of a primary or secondary container shall be separated in both the primary and secondary containment so as to avoid intermixing.

9. If the tank is a vertical tank & if it has the leak at the middle, the dyke should be constructed in such a way that - considering the travelling distance of the material due to its head.



this is what I have now. these are universal practices.

apart from this, I don't have the answer for the question kidly specify where it is mentioned (ACT/Rule etc.) if you want the rules, I'm helpless & I will try to look into this, but not immediately, as I'm unable to concentrate on this.

y'day I missed ur thread & so once again a late sharing of the points. kindly bear with me.

dear tgpenney, thank u for the inputs.

dear dipil, I need to have a look on your link.

dear srinivas, could u pls. tell from where u got this 1.25. this point is new for me.

hope abhay can get something out from this explanation.

From India, Delhi
tgpenney@gmail.com
11

Mr SRINIVASAN

Is absolutely right the 1.25 holding cap this allows for the chemical being held plus contamentation factor of water

Plus the other part of the formula is can the other chemicals in the holding area be mixed are they compatable if mixed together or will they react with water if they leak and it has rained the same can be said for the acid based products plus some chemicals need a secondary containment wall or area

And always review and redo all emergency response plans and fire control plans to allow for quick and effective control

The US Chemical Safety Board is a good source for this type of data plus they also not making sure all exterior piping is checked and re-risk assessment is done including tank breather valves and hatch lids they have a excellant video on this in there library of material

Alberta and California have about the best data on chemicals and berm or dyke operations if you need examples for construction purposes plus Im sure your own country has its own chemical - dangerous goods - hazmat department with local or provincial guidelines

Plus most insurance companies have there set of guidelines inplace because of insurance reviews

From Canada, Calgary
Community Support and Knowledge-base on business, career and organisational prospects and issues - Register and Log In to CiteHR and post your query, download formats and be part of a fostered community of professionals.





Contact Us Privacy Policy Disclaimer Terms Of Service

All rights reserved @ 2024 CiteHR ®

All Copyright And Trademarks in Posts Held By Respective Owners.